Figure 49. The Cable Connection In Case Of Providing Rear External Com Port - Intel SRSH4 - Server Platform - 0 MB RAM Service Manual

4. In case of providing COM interface onto rear external port
Remove "
F/P SERIAL CABLE(060)
basic configuration. Instead by using "
kit of system unit", connect between "Serial connector on Baseboard" and rear external COM
interface port.
Cable names
A U320 SCSI CABLE (104) BB-HDDBA
B BOX-34P CABLE(BEND1)
C FDD CABLE(025)
D IDE SIGNAL CABLE(BEND1)
E HOT-PLUG PCI 28PIN CABLE(0.16)
F FAN SIGNAL CABLE(040)
G IPMB CABLE(035)
H ICMB CABLE(035)
I F/P USB CABLE(160)
J RJ45 SERIAL CABLE(135)
K OPEN SENSER CABLE(040)
L SCSI 3CONN TERM (160M)(001)

Figure 49. The cable connection in case of providing rear external COM port

Installing and Removing Components
" which had been connected to Serial connector on Baseboard at
RJ45 SERIAL CABLE(035)
Part Numbers Qty.
804-063107-1040 1
808-744465-501 1
804-062337-525 1
804-062050-501 1
804-062719-516 1
804-062929-040 1
804-062930-035 1
804-062931-035 1
804-062932-160 1
804-062988-135 1
804-062937-040 1
804-062989-001 1
" which is attached in "Accessory
Dimensions Descriptions
SCSI(ch.A) on Baseboard – HDD
1040mm
Cage
705mm For signals of Front Panel board
250mm FDD signals
Signals for CDROM(master) and
500mm
extension devices(slave)
165mm For signals of HPIB
345mm For signals of FAN BP
370mm IPMB signals for HDD cage
355mm ICMB signals
595mm USB signals on Front Panel board
"SERIAL" on Baseboard – external
350mm
"COM B" port
420mm Chassis intrusion
SCSI(ch.B) on Baseboard –
640mm
internal peripherals
J
83