Post Error Messages - Intel SRSH4 - Server Platform - 0 MB RAM Service Manual

POST Error Messages

When POST detects an error, it displays an error message on the display unit screen. The following table lists error
messages, descriptions, and actions to take.
IMPORTANT:
service representative. Alarm messages are useful information for maintenance.
Error
Error message
code
0200 Failure Fixed Disk.
0210 Stuck Key.
0211 Keyboard error.
0212 Keyboard Controller Failed.
0213 Keyboard locked - Unlock key
switch.
0220 Monitor type does not match CMOS
- Run SETUP.
0230 System RAM Failed at offset.
0231 Shadow Ram Failed at offset.
0232 Extended RAM Failed at address
line.
System battery is dead - Replace
0250
and run SETUP.
0251 System CMOS checksum bad -
Default configuration used.
0252 Password checksum bad -
Passwords cleared.
0260 System timer error.
0270 Real time clock error.
0271 Check date and time setting.
0280 Previous boot incomplete – Default
configuration used
02B0 Diskette drive A error.
02B1 Diskette drive B error.
02B2 Incorrect Drive A type - run SETUP.
02B3 Incorrect Drive B type - run SETUP.
Solving Problems
Take a note on the messages displayed before consulting with your
Recommended Action
Contact your service representative.
Disconnect the keyboard and connect it again.
isconnect the keyboard and connect it again.
estart the system. If the error cannot be
corrected, contact your service representative.
Release the lock of the key switch. If the error cannot
be corrected in spite of the release of the lock, contact
your service representative.
Start the SETUP. If the error cannot be corrected in
spite of the start of SETUP, contact your service
representative.
Contact your service representative.
Contact your service representative to replace the
battery. (After restarting the computer, start the
SETUP to provide the setting again.)
The default values have just been set. Start the
SETUP to provide the setting again. If the error cannot
be corrected, contact your service representative.
The password has just been cleared. Start the SETUP
to provide the setting again.
Start the SETUP to set the date and time again. If the
same error occurs successively in spite of the
resetting, contact your service representative.
Contact your service representative.
Start the SETUP to set the "Legacy Floppy A" and
"Legacy Floppy B" in the Main menu again. If the
same error occurs successively in spite of the
resetting, contact your service representative.
Start the SETUP to provide the setting again. If the
error cannot be corrected, contact your service
representative.
93