Removing And Installing The Bezel; Figure 2. Attaching The Bezel To The Chassis - Intel SRSH4 - Server Platform - 0 MB RAM Service Manual

Removing and Installing the Bezel

You need to remove the bezel to install and remove hot-swap power supplies and to install and
remove devices in the 5.25-inch peripherals bay. The bezel has ball studs (Figure 2, A) on the back
that snap-fit into holes on the chassis front.
•
To remove the bezel,
1. Unlock the security key
2. Grasp the right edge of the front bezel and pull the bezel towards you to open it.
3. Slide the front bezel left to disengage the mounting tabs and remove the front bezel from the
chassis.
•
To install the bezel, Position the front bezel so the mounting tabs of the front bezel are aligned
with their mounting holes on the front of the system. Slide the bezel right until the bezel snaps
into place.

Figure 2. Attaching the Bezel to the Chassis

28