Table of Contents
Advertisement
2 Getting Started
This section discusses the main steps you need to perform to get your server up and running:
1. Select an appropriate site.
2. Install processors, memory, hard disk drives, and other options.
3. Connect the monitor, keyboard, and mouse.
4. Turn on the server and boot to the NEC EXPRESSBUILDER CD-ROM.
5. Install the service partition.
6. Install an operating system.
7. Set up system security.
8. Install the server into a rack unit.
Selecting a Site
This section describes the space and power requirements and general site criteria for installing the
server.
Figure 1. EXPRESS5800/140Rc-4 Server
16
Advertisement
Table of Contents
Need help?
Do you have a question about the SRSH4 - Server Platform - 0 MB RAM and is the answer not in the manual?