Figure 35. Replacing The Backup Battery - Intel SRSH4 - Server Platform - 0 MB RAM Service Manual

VAROITUS!
Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo
ainoastaan laitevalmistajan suosittelemaan tyyppiin. Hävitä käytetty paristo
valmistajan ohjeiden mukaisesti.
To replace the battery:
1. Before proceeding, record your custom BIOS settings.
2. Disconnect the AC power cords from the power source or wall outlets.
3. Turn off all peripheral devices connected to the server system.
4. Remove the rear access cover (page 29), the system board access cover (page 32), the memory
board (page 33), the air baffle (page 35), and the processor board (page 37).
5. Slide the battery in the direction shown in Figure 35, allowing the battery to pop up.
6. Remove the battery from its socket.
7. Dispose of the battery according to local ordinance.
8. Remove the new lithium battery from its package.
9. Being careful to observe the correct polarity, lay the battery in the socket, inserting one edge of
the battery under the large corner tabs.
10. Push the battery down until it locks into the socket.
11. Install the processor board, air baffle, memory board, system board access cover, and the rear
access cover.
12. Run BIOS Setup to restore the configuration settings to the RTC.
13. Restore your custom BIOS settings.

Figure 35. Replacing the Backup Battery

66