Table of Contents
Advertisement
8. Remove the plastic protective overlay covering the PCI area of the board as follows:
a. Unscrew the captive screw holding the overlay in place (Figure 12, D).
b. Near the middle of the baseboard, lift the edge of the overlay until it is clear of the
connectors on the board (Figure 12, B).
c. Slide the overlay toward the front of the electronics bay and unhook it from the two tabs
(Figure 12, C).
d. Remove the overlay.
9. Remove the six screws, the plastic overlay, and the two processor board mounting brackets that
attach the baseboard to the electronics bay (Figure 13, A).
10. Lifting the board slightly, slide the baseboard toward the front of the chassis until the I/O ports
clear the chassis.
11. At one side of the chassis, the board is inserted into slots in a foam panel (Figure 13, B). Lift up
on the opposite end of the board and pull the edge of the board out of the slots in the foam panel.
12. Lift the baseboard out of the electronics bay and place it component-side up on a nonconductive,
static-free surface (or in an antistatic bag).
Figure 13. Baseboard Mounting
40
Advertisement
Table of Contents
