Intel SRSH4 - Server Platform - 0 MB RAM Service Manual page 96

Error
Error message
code
0B92 Internal Use Area of BMC FRU
corrupted.
0B93 BMC SDR Repository empty.
0B94 IPMB signal lines do not respond.
0B95 BMC FRU device failure.
0B96 BMC SDR Repository failure.
0B97 BMC SEL device failure.
0B98 BMC RAM test error.
0B99 BMC Fatal hardware error.
0B9A BMC not responding.
0B9B Private I2C bus not responding.
0B9C BMC internal exception.
0B9D BMC A/D timeout error.
0B9E SDR repository corrupt.
0B9F SEL corrupt.
0BB0 SMBIOS - SROM data read error.
0BB1 SMBIOS - SROM data checksum
bad.
0BC0 POST detected startup failure of 1st
Processor.
0BC1 POST detected startup failure of
2nd Processor.
0BD0 1st SMBus address not
acknowledged.
0BD1 1st SMBus device Error detected.
0BD2 1st SMBus timeout.
0BD3 2nd SMBus address not
acknowledged.
0BD4 2nd SMBus device Error detected.
0BD5 2nd SMBus timeout.
0BD6 3rd SMBus address not
acknowledged.
0BD7 3rd SMBus device Error detected.
0BD8 3rd SMBus timeout.
Recommended Action
All the commands and functions other than the FRU
command and the EMP function can be used. This is
not a fatal error. Turn off the power once and then on
again to restart the server. If the error cannot be
corrected, contact your service representative.
Turn off the power once and then on again to restart
the server. If the error cannot be corrected, contact
your service representative.
All the functions other than the function of accessing to
SMC through IPMB can be used. This is not a fatal
error. Turn off the power once and then on again to
restart the server. If the error cannot be corrected,
contact your service representative.
All the commands and functions other than the FRU
command and the EMP function can be used. This is
not a fatal error. Turn off the power once and then on
again to restart the server. If the error cannot be
corrected, contact your service representative.
Turn off the power once and then on again to start the
server. If the error cannot be corrected, contact your
service representative.
Contact your service representative.
Contact your service representative to replace the
CPU.
Contact your service representative to replace the
board specified in the system event log.
96