Configuring Mpls - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

CHAPTER 4

Configuring MPLS

Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to configure Multiprotocol Label Switching (MPLS) on the
router, and contains the following sections:
Basic MPLS Configuration Tasks on page 276
MPLS Global Configuration Tasks on page 277
LDP and RSVP-TE Interface Profile Configuration Tasks on page 280
MPLS Interface Configuration Tasks on page 281
MPLS Tunnel Configuration Tasks on page 283
MPLS Tunnel Profile Configuration Tasks on page 285
Configuring Explicit Routing for MPLS on page 286
Additional LDP Configuration Tasks on page 288
Configuring LDP FEC Deaggregation on page 288
Configuring LDP Graceful Restart on page 289
Configuring LDP Autoconfiguration on page 290
Configuring LDP-IGP Synchronization on page 291
Configuring LDP MD5 Authentication on page 291
Controlling LDP Label Distribution on page 292
Additional RSVP-TE Configuration Tasks on page 293
Configuring RSVP MD5 Authentication on page 294
Configuring RSVP-TE Fast Rerouting with RSVP-TE Bypass Tunnels on page 295
Configuring RSVP-TE Hello Messages to Determine Peer Reachability on page 297
Configuring RSVP-TE Graceful Restart on page 299
Configuring RSVP-TE Hellos Based on Node IDs on page 299
Configuring the BFD Protocol for RSVP-TE on page 300
Configuring IGPs and MPLS on page 301
Configuring MPLS and Differentiated Services on page 304
Configuring the Tunneling Model for Differentiated Services on page 305
Configuring EXP Bits for Differentiated Services on page 305
Example Differentiated Services Application and Configuration on page 305
275