EPSON Stylus PHOTO 2100/2200
4.2.2.3 Removing the Main Board
1.
Remove the Board Unit. (Refer to 4.2.2.2.)
2.
Disconnect the Connector Cable from CN15 of the Main Board.
"
CN15 has a connector cable lock mechanism. Therefore, before
disconnecting the Connector Cable, make sure that the lock
mechanism has been cleared. When reconnecting the cable,
insert the pins correctly into the corresponding ports of CN15.
Refer to Figure 4-17, "Connector Cable Lock Mechanism".
"
Mount the pin side, where a blue line is drawn on the Connector
Cable, to the 1 pin side.
Refer to Figure 4-17, "Connector Cable Lock Mechanism".
Blue line
1 pin side
CN15
Figure 4-17. Connector Cable Lock Mechanism
DISASSEMBLY AND ASSEMBLY
1
2
1
Disassembly
3.
Remove the five screws 6) C.B.S 3
(6±1kgf.cm) that secure the Main Board, and remove the Main Board.
Main Board
1
C.B.S 3×6
2
5
Figure 4-18. Screws That Secure the Main Board
Fit the screws 6) C.B.S 3
Revision B
×
6 (9±1kgf.cm) and three screws 7) C.P 3
C.P 3×6
3
4
×
6 in the order shown in Figure 4-18.
×
6
129