Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual page 173

EPSON Stylus PHOTO 2100/2200
8. Remove the Torsion Spring 7.13 that engages the DE Unit, ASF/Pump Motor and
Under Frame.
Circuit Board
C.B.P 3×8
Torsion Spring 7.13
Rear left side
Figure 4-118. Removing the Torsion Spring 7.13
When reinstalling the Torsion Spring 7.13, bring the straight leg
tip into contact with the ASF/Pump Motor, and hitch the other leg
tip on the hole in the Under Frame.
Refer to Figure 4-118, "Removing the Torsion Spring 7.13".
9. Remove the one screw 6) C.B.S 3
(6±1kgf.cm) that secure the DE Unit.
Front right side
C.B.P 3×8
Figure 4-119. Screws That Secure the DE Unit
DISASSEMBLY AND ASSEMBLY
Hole in Under
Frame
ASF/Pump Motor
Front right side
×
6 (9±1kgf.cm) and one screw 14) C.B.P 3
C.B.S 3×6
10. Slide the DE Unit rear side to the printer left side as seen from the printer rear, pull
off the DE Unit upper side to the front, and remove the DE Unit together with the
ASF/Pump Motor.
Figure 4-120. Removing the DE Unit
×
8
Disassembly
Revision B
DE Unit
2
1
173