EPSON Stylus PHOTO 2100/2200
9.
While pushing the Driven Pulley Holder to the right as seen from the printer front,
loosen the Timing Belt and remove the Timing Belt from the Pinion Gear of the
CR Motor.
Driven Pulley Holder
Figure 4-75. Removing the Timing Belt
10. Remove the Compression Spring 24.5 mounted on the Driven Pulley Holder.
11. Slide the Driven Pulley Holder to the right, as seen from the printer front, to
remove the Driven Pulley Holder from the Frame.
12. Remove the PG Change Link from the PG Change Lever.
(Refer to Steps 2 and 3 in 4.2.8.)
DISASSEMBLY AND ASSEMBLY
CR Motor
Pinion Gear
Timing Belt
Disassembly
13. Release the hook of the PG Change Lever and remove the PG Change Lever from
the Carriage Guide Shaft A.
Handle the hook of the PG Change Lever fully carefully since it is
easily damaged.
Refer to Figure 4-76, "Removing the PG Change Lever".
C.B.S(P4) 3×6
Printer right side
Figure 4-76. Removing the PG Change Lever
Revision B
PG Change
Lever
Hook
154