EPSON Stylus PHOTO 2100/2200
4.2.7 Removing the Printhead
1.
Remove the Middle Housing. (Refer to 4.2.1.3.)
2.
Remove the Ink Cartridges.
3.
Pull and release the two left and right joggles, which secure the I/C Cover to the
Carriage Unit, inward and remove the I/C Cover from the Carriage Unit.
I/C Cover
Figure 4-56. Removing the I/C Cover
DISASSEMBLY AND ASSEMBLY
Joggles
4.
Move the Carriage Unit to the printer center.
5.
Release the four hooks that secure the Head Cable Holder to the Carriage Unit, and
lift and remove the Head Cable Holder from the Carriage Unit.
Figure 4-57. Removing the Head Cable Holder
6.
Release the Torsion Spring 66 from the hook of the Head Fastener.
7.
Remove the two screws 8) C.B.P 3
Torsion Spring 66
Hook
Carriage Unit
left side
Figure 4-58. Removing the Screws That Secure the Head Fastener
Disassembly
Head Cable
Holder
Hooks
Hooks
×
6 (6±1kgf.cm) that secure the Head Fastener.
Head Fastener
C.B.P 3×6
Revision B
Carriage Unit
rear
Carriage Unit
Carriage Unit
right side
right side
146