Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual page 160

EPSON Stylus PHOTO 2100/2200
When reinstalling the PG Change Spring Lever, Intermittent Gear
24, 30 and Release Connect Lever, always match the phase marks
that are also shown in the left photo in Figure 4-86.
The C Ring that secures the Release Connect Lever is larger than
the C Ring that secures the PG Change Lever.
Refer to Figure 4-86, "Removing the Gears".
When removing the Release Connect Lever, fully be careful not to
lose the Parallel Pin since it may come off.
Refer to Figure 4-86, "Removing the Gears".
5. Remove the one screw 6) C.B.S 3
right end of the Release Lever Shaft as seen from the printer rear, pull the right end
of the Cover to the front to release the hook on the left end of the Cover, and
remove the Cover.
Release Lever Shaft
Printer rear left side
Figure 4-87. Removing the Cover
DISASSEMBLY AND ASSEMBLY
×
6 (9±1kgf.cm) that secures the Cover on the
Cover
C.B.S 3×6
6. Releasing the Torsion Springs 117.9 that secure the Driven Rollers as viewed from
the printer rear disengages the Release Lever Shaft from the hooks on the Frame.
Figure 4-88. Releasing the Torsion Springs 117.9
7. Pull the Release Lever Shaft to the right, as seen from the printer rear, to remove.
"
When reinstalling the Release Lever Shaft, face the round part of
its end downward, and then turn it counterclockwise to face the
round part upward.
Refer to Figure 4-89, "How to Install the Release Lever Shaft".
Round part
Figure 4-89. How to Install the Release Lever Shaft
Disassembly
Torsion Springs 117.9
Driven Rollers
Revision B
160