EPSON Stylus PHOTO 2100/2200
"
When changing the Main Board, the following part change and
adjustments are necessary. Perform the adjustments in the
following order.
Parts to be changed
•
Waste Ink Pads
Adjustment items
1.
EEPROM data
2.
EEPROM initialization
3.
USB ID input
4.
IEEE-1394 ID input
5.
Head ID input
6.
Bi-D adjustment
7.
Pixel Shift Adjustment
8.
PF adjustment
9.
PW sensor mounting position adjustment
10. CR Motor drive torque dispersion measurement
(maximum correction value input)
"
Refer to "Chapter 5 Adjustment" for the adjustment
procedures.
"
When data can be read from the old Board, adjustments and
Waste Ink Pad changing are not necessary.
DISASSEMBLY AND ASSEMBLY
4.2.2.4 Removing the PSB/PSE Board
1.
Disconnect the Connector Cable from CN15 of the Main Board.
(Refer to Steps 1 and 2 in 4.2.2.3.)
2.
Remove the four screws 6) C.B.S 3
(6±1kgf.cm) that secure the PSB/PSE Board, and remove the PSB/PSE Board
from the Board Unit.
1
PSB/PSE
Board
C.B.S 3×6
2
Figure 4-19. Screws That Secure the PSB/PSE Board
"
Fit the screws 8) C.B.P 3
"
Always fit the Protective Sheet under the PSB/PSE Board after
matching the two screw holes with those of the Board Unit.
Refer to Figure 4-20, "Fitting the Protective Sheet".
Disassembly
×
6 (9±1kgf.cm) and two screws 8) C.B.P 3
4
C.B.P 3×6
3
×
6 in the order shown in Figure 4-19.
Screw holes
Figure 4-20. Fitting the Protective Sheet
Revision B
×
6
Protective Sheet
130