EPSON Stylus PHOTO 2100/2200
4.2.18.2 Removing the Cutter Motor
1.
Remove the Cutter Housing. (Refer to Steps 1 and 2 in 4.2.18.1.)
2.
Disconnect the Connector Cable (CN2) from the Driver Board and release it from
the Harness Clamp.
Harness Clamp
Figure 4-143. Disconnecting the Connector
DISASSEMBLY AND ASSEMBLY
3.
Connector
Driver Board
Disassembly
×
Remove the two screws 16) C.P 2.5
3 (4±0.5kgf.cm) that secure the Cutter Motor,
and while pulling and stretching the Timing Belt, remove the Pinion Gear of the
Cutter Motor and remove the Cutter Motor from the Cutter Unit.
C.P 2.5×3
Timing Belt
Figure 4-144. Screws That Secure the Cutter Motor
Revision B
Cutter Motor
Pinion Gear
184