Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual page 133

EPSON Stylus PHOTO 2100/2200
5. With the Roll Paper Guide and ASF Unit viewed from the rear, pull the right end
of the Roll Paper Guide to the right to remove it from the joggle on the ASF Unit
right side, and then remove the Roll Paper Guide from the joggle on the ASF Unit
left side.
Joggle
ASF Unit left side
Figure 4-25. Removing the Roll Paper Guide
"
Before reinstalling the Roll Paper Guide, insert the joggle on the
ASF Unit left side, as viewed from the ASF Unit rear, into the
mounting hole of the Roll Paper Holder.
Refer to Figure 4-25, "Removing the Roll Paper Guide".
"
Insert the round joggle on the ASF Unit front bottom right side,
as viewed from the ASF Unit front, into the mounting hole of the
Middle Frame located on the left of the printer center as viewed
from the printer rear.
Refer to Figure 4-26, "Reinstalling the ASF Unit 1".
Mounting
Combinati
on Gear
14, 28
Middle Frame
Figure 4-26. Reinstalling the ASF Unit 1
DISASSEMBLY AND ASSEMBLY
Joggle
ASF Unit right side
ASF Unit
hole
right side
Spur Gear
Joggle
"
When reinstalling the ASF Unit, insert the joggle under the left
side, as viewed from the printer rear, into the Lower Frame, and
the joggle on the rear side into the Front Frame, and make sure
that the tooth surface of the Spur Gear 32 in the ASF Unit
engages with the tooth surface of the Combination Gear 14, 28 in
the DE Unit.
Refer to Figure 4-27, "Reinstalling the ASF Unit 2".
ASF rear
right side
When changing the ASF Unit, make the following adjustment.
• PW sensor mounting adjustment
front
bottom
32
Disassembly
Joggle
Joggle
Figure 4-27. Reinstalling the ASF Unit 2
Revision B
133