EPSON Stylus PHOTO 2100/2200
Occurrence Timing
Phenomenon Detail
At roll paper feeding
After the roll paper is fed, the
by auto loading
Paper LED indicates Blink 2.
At roll paper feeding When the roll paper is fed, the
Cutter produces operating noise.
At roll paper cutting When the roll paper is cut, the
paper is cut only halfway.
TROUBLESHOOTING
Table 3-14. Phenomenon-Based Cutter Jam Error Check Points
Faulty Part/
Part Name
Cutter motor
1. Check that the connector cable of the Cutter motor is connected to
CN2 on the Driver board correctly.
Cutter motor
2. Check the Cutter motor for a failure.
3. Check the Cutter motor connector cable for damage.
Cutter unit
1. Check the rail groove of the Cutter for paper dust, foreign matter,
etc.
Cutter unit
1. Check that the paper used is not other than the EPSON special
media.
2. Check the Cutter for damage.
Troubleshooting
Check Point
Driver board
CN2
Revision B
Remedy
1. Connect the connector cable of the Cutter
motor to CN2 on the Driver board securely.
2. Change the Cutter motor for a new one.
3. Change the Cutter motor for a new one.
1. Remove the paper dust, foreign matter, etc.
from the rail groove of the Cutter.
1. Use the EPSON special media.
2. Change the Cutter unit for a new one.
93