Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual page 138

EPSON Stylus PHOTO 2100/2200
16. Remove the Compression Spring 3.13 that engages the Hopper and Left LD Roller
Unit as seen from the ASF Unit front, and remove the Left LD Roller Unit from
the Hopper.
17. Remove the Compression Spring 1.961 that engages the Hopper and Right LD
Roller Unit as seen from the ASF Unit front, and slide the Right LD Roller Unit to
the right to remove the Right LD Roller Unit from the Arm of the Hopper.
Compression
Spring 1.961
Right LD
Roller Unit
Figure 4-36. Removing the LD Roller Units
"
Place the Compression Springs into the Left and Right LD Roller
Units correctly. (Place the Compression Spring 1.961 on the right
and the Compression Spring 3.13 on the left.)
Refer to Figure 4-36, "Removing the LD Roller Units".
DISASSEMBLY AND ASSEMBLY
Compression
Spring 3.13
Left LD Roller
Unit
Disassembly
"
When reinstalling the Compression Spring that engages the
Hopper and LD Roller Unit, pre-fix it to the hooks of the Spring
Support in the LD Roller Unit. After installing it to the ASF
Frame, release the hitched Spring from the rear hole in the ASF
Frame. (This also applies to the Right LD Roller Unit.)
Refer to Figure 4-37, "Installing the Compression Spring".
Hooks
Figure 4-37. Installing the Compression Spring
Revision B
Rear hole
138