Overview; Error Indications And Fault Occurrence Causes - Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus PHOTO 2100/2200

3.1 Overview

This chapter describes unit-level troubleshooting.

3.2 Error Indications and Fault Occurrence Causes

This section explains the LED indications, EPW3 messages and fault occurrence causes at occurrence of the following errors during any sequence/operation (e.g. power-on
sequence, paper feeding/loading sequence, ink sucking sequence).
Printer Condition
Power
Communication Error -
Model Difference -
"-" : don't care
Blink : 0.5sec on + 0.5sec off repetition
Blink 2 : 0.2sec on + 0.2sec on + 0.2sec on 0.4sec off repetition
TROUBLESHOOTING
Table 3-1. Error Indications and Fault Occurrence Causes
Indicators
Paper Ink 1-7
- -
- -
EPSON Printer Window 3
High speed Blink : 0.1sec on + 0.1sec off repetition
Blink alternately 1 : 0.5sec on + 0.5sec off repetition
Blink alternately 2 : 0.5sec on + 0.5sec on repetition
Overview
Fault Occurrence Cause
This error is detected when the printer cannot
communicate with the PC properly.
Examples are as follows.
1. The connection port differs from the port used on the
driver.
2. Main board fault.
3. Power supply board fault.
CAUTION: Since D4 is also supported by the parallel
interface, communication can be made if
Fatal error occurs. Therefore, this error is
narrowed down to the above causes.
This error is detected if a different product is connected
to the printer driver.
1. Mismatch between the printer driver and product
2. The EEPROM E0<H> area data differs from the
specifications.
Revision B
70