Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual page 169

EPSON Stylus PHOTO 2100/2200
8. Remove the two screws 13) C.P.S 3
remove the CR Motor from the Upper Frame.
Figure 4-107. Removing the CR Motor
"
When reinstalling the CR Motor, face the label of the CR Motor
rightward as seen from the printer rear.
Refer to Figure 4-108, "Installing the CR Motor".
Figure 4-108. Installing the CR Motor
"
After installing the CR Motor, fully use care not to damage the
tooth surface of the Pinion Gear.
Refer to Figure 4-107, "Removing the CR Motor".
DISASSEMBLY AND ASSEMBLY
×
6 (6±1kgf.cm) that secure the CR Motor, and
C.P.S 3×6
CR Motor
Label
"
When changing the CR Motor, make sure that the Ferrite Core
is fitted to the Cable securely.
Ferrite Core
Figure 4-109. Checking the Ferrite Core
"
When changing the CR Motor, the following adjustments are
necessary. Make the adjustments in the following order.
1. CR tooth skip prevention mechanism adjustment
2. CR motor drive torque dispersion measurement
(maximum correction value input)
"
Refer to "Chapter 5 Adjustment" for the adjustment
procedures.
Disassembly
Revision B
169