Removing The Board Assembly - Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus PHOTO 2100/2200

4.2.2 Removing the Board Assembly

4.2.2.1 Removing the Panel Board
1. Remove the Upper Housing. (Refer to 4.2.1.1.)
2. Remove the three screws 5) C.B.P 3
Plate and Panel Board, and remove the Grounding Plate and Panel Board from the
Upper Housing.
Grounding Plate
C.B.P 3×10
Figure 4-13. Screws That Secure the Grounding Plate and Panel Board
DISASSEMBLY AND ASSEMBLY
×
10 (6±1kgf.cm) that secure the Grounding
C.B.P 3×10
Panel Board
4.2.2.2 Removing the Board Unit
1. Remove the Rear Housing. (Refer to 4.2.1.2.)
2. Remove the five screws 6) C.B.S 3
(9±1kgf.cm) that secure the Board Unit, slightly pull the Board Unit to the front as
viewed from the printer rear, and disengage the Ferrite Cores located on the Lower
Frame and Board Unit side using a flat-blade screwdriver.
C.B.S 3×6
3 5 1
Board Unit
Figure 4-14. Screws That Secure the Board Unit
Disassembly
×
6 (9±1kgf.cm) and one screw 2) C.B.S 3
2 4
C.B.S 3×10
Ferrite Cores
Revision B
×
10
Rear right side
127