Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual page 185

EPSON Stylus PHOTO 2100/2200
4.2.18.3 Removing the Driver Board
1. Remove the Cutter Housing. (Refer to Steps 1 and 2 in 4.2.18.1.)
2. Disconnect all Connector Cables from the Driver Board.
"
CN2 has a connector cable lock mechanism. Therefore, before
disconnecting the Connector Cable, make sure that the lock
mechanism has been cleared. When reconnecting the cable,
insert the pins correctly into the corresponding cutouts of CN2.
Refer to Figure 4-145, "Connector Cable Lock Mechanism".
"
Mount the pin side, where a blue line is drawn on the Connector
Cable, to the 1 pin side.
Refer to Figure 4-145, "Connector Cable Lock Mechanism".
CN2
Blue line
Figure 4-145. Connector Cable Lock Mechanism
DISASSEMBLY AND ASSEMBLY
2
1
1 pin side
1
3. Remove the two screws 6) C.B.S 3
Driver Board.
4. Slide the Board Plate and Driver Board together to the left as viewed from the
Cutter Unit front to release the two hooks, and after removing the Board Plate and
Driver Board from the Cutter Unit, remove the Driver Board from the Board Plate.
C.B.S 3×6
Driver Board
Figure 4-146. Removing the Driver Board
Insert the Driver Board into the notches of the Board Plate.
Refer to Figure 4-146, "Removing the Driver Board".
Disassembly
Revision B
×
6 (9±1kgf.cm) that secure the Board Plate and
Board Plate
Notches
C.B.S 3×6
Hooks
185