Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual page 165

EPSON Stylus PHOTO 2100/2200
To connect the FFC of the PW Sensor, pass it around the Arm of
the PW Sensor Cover and the rear side of the Bearing on the left
side (as seen from the printer front) of the Carriage Unit and into
the hook on the rear left of the Carriage Unit, and return it
between the hook and the Connector of the CR Encoder Sensor
Board, and connect it to the Connector of the CR Encoder Sensor
Board.
Refer to Figure 4-100, "Routing the FFC".
Arm
FFC
Figure 4-100. Routing the FFC
"
When removing or changing the PW Sensor, the following
adjustments are necessary. Make the adjustments in the
following order.
1. PG adjustment
2. CR tooth skip prevention mechanism adjustment
3. Head cleaning
4. Head angular adjustment
5. Bi-D adjustment
6. Pixel Shift Adjustment
7. PW sensor mounting position adjustment
"
Refer to "Chapter 5 Adjustment" for the adjustment
procedures.
DISASSEMBLY AND ASSEMBLY
Bearing
Connector
4.2.12.6 Removing the CR Encoder Sensor Board
1. Remove the Carriage Unit. (Refer to 4.2.9.)
2. Remove the three screws 12) C.P.B (P1) 1.7
CR Encoder Sensor Board.
3. Disconnect the FFC, which is connected to the CR Encoder Sensor Board, from
the Connector, and remove the CR Encoder Sensor Board.
2
Hook
Grounding Plate
Figure 4-101. Removing the CR Encoder Sensor Board
Disassembly
×
5 (1.5±0.25kgf.cm) that secure the
CR Encoder Sensor Board
1
C.P.B(P1) 1.7×5
Connector
Revision B
3
FFC
Hook
165