Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual page 145

EPSON Stylus PHOTO 2100/2200
6. Release the Grounding Wire, which is located on the left side of the Paper Eject
Roller B as seen from the printer front, from the Left Frame, and remove it from
the Paper Eject Roller B.
Figure 4-54. Removing the Grounding Wire
7. Remove the joggles of the Bushes 6, which secure the left and right of the Paper
Eject Roller B to the left and right of the Frame, from the left and right of the
Frame, and turn them upward.
Bush 6
Figure 4-55. Removing the Bushes 6
DISASSEMBLY AND ASSEMBLY
Grounding Wire
Bush 6
8. Lift the right end of the Paper Eject Roller B as seen from the printer front to
remove it from the Right Frame, move the right end of the Paper Eject Roller B to
the front, remove the Bush 6 on the left end from the Left Frame, and then remove
the Paper Eject Roller B.
"
After changing the Lower Paper Guide for a new one, always
apply grease G-45 to the specified portions.
Refer to Chapter 6, Figure 6-9, "Lubrication Point 11".
Refer to Chapter 6, Figure 6-10, "Lubrication Point 12".
Disassembly
Revision B
145