Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual page 124

EPSON Stylus PHOTO 2100/2200
An easy way to reinstall the Rear Housing is to insert the upper
hooks of the Rear Housing into the Middle Housing, mount the
Rear Housing using the two upper hooks as supports, and fit the
cutouts of the Rear Housing into the lower hooks of the Lower
Housing.
Refer to Figure 4-8, "Hooks and Cutouts That Secure the Rear
Housing".
DISASSEMBLY AND ASSEMBLY
4.2.1.3 Removing the Middle Housing
1. Remove the Upper Housing. (Refer to 4.2.1.1.)
2. Remove the two screws 3) C.B.P 3
Housing, from the Middle Housing.
Middle Housing
Front left
C.B.P 3×14
side
Figure 4-9. Screws That Secure the Middle Housing
3. Release the six hooks, which secure the left and right of the Middle Housing, from
the Lower Housing, and while turning the Middle Housing rearward as viewed
from the printer front, lift it to remove.
By pushing the cutouts of the Lower Housing toward the printer inside one by one
to disengage them from the hooks of the Middle Housing, you can release the
hooks easily.
Hooks
Figure 4-10. Hooks That Secure the Left and Right of the Middle Housing
Disassembly
Revision B
×
14 (6±1kgf.cm), which secure the Middle
C.B.P 3×14
Front right side
Hooks
124