Match Ip6Flowlbl; Match Cos; Match Secondary Cos - NETGEAR ProSAFE M7100-24X Reference Manual

ProSAFE M7100 Managed Switches
cases, each removal of a refclass rule reduces the maximum number of available rules in the
class definition by one.
no match class-map
This command removes from the specified class definition the set of match conditions defined
for another class. The <refclassname> is the name of an existing DiffServ class whose match
conditions are being referenced by the specified class definition.
Format
no match class-map <refclassname>
Mode • Class-Map Config
• Ipv6-Class-Map Config

match cos

This command adds to the specified class definition a match condition for the Class of Service
value (the only tag in a single tagged packet or the first or outer 802.1Q tag of a double VLAN
tagged packet). The value might be from 0 to 7.
Default none
Format
match cos <0-7>
Mode • Class-Map Config
• Ipv6-Class-Map Config

match secondary cos

This command adds to the specified class definition a match condition for the secondary Class of
Service value (the only tag in a single tagged packet or the first or outer 802.1Q tag of a double
VLAN tagged packet). The value might be from 0 to 7.
Default none
Format
match secondary-cos <0-7>
Mode Class-Map Config

match ip6flowlbl

This command adds to the specified class definition a match condition based on the IP6flowlbl of
a packet. The label is the value to match in the Flow Label field of the IPv6 header (range
0-1048575).
Format
match ip6flowlbl <label>
Mode Ipv6-Class-Map Configuration mode
Quality of Service (QoS) Commands
231