Configuring Timezones Settings; Configuring Ntp; Configuring A Cisco Router To Be An Ntp Server; Configuring The Sensor To Use An Ntp Time Source - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual
Configuration guide
Hide thumbs
Also See for 4215 - Intrusion Detection Sys Sensor:
- Hardware installation manual (74 pages)
Table of Contents
Advertisement
Chapter 4
Initial Configuration Tasks
Configuring Timezones Settings
Use the time-zone-settings command to configure the timezone settings on the sensor, such as the
timezone name the sensor displays whenever summertime settings are not in effect and the offset.
To configure the timezone settings on the sensor, follow these steps:
Step 1
Log in to the sensor using an account with administrator privileges.
Step 2
Enter timezone settings submode:
sensor# configure terminal
sensor(config)# service host
sensor(config-hos)# time-zone-settings
Configure the timezone name that is displayed whenever summertime settings are not in effect:
Step 3
The default is UTC.
sensor(config-hos-tim)# standard-time-zone-name CST
Configure the offset in minutes:
Step 4
The offset is the number of minutes you add to UTC to get the local time. The default is 0.
sensor(config-hos-tim)# offset -360
Note
Verify your settings:
Step 5
sensor(config-hos-tim)# show settings
time-zone-settings
-----------------------------------------------
-----------------------------------------------
sensor(config-hos-tim)#
Exit timezone settings submode:
Step 6
sensor(config-hos-tim)# exit
sensor(config-hos)# exit
Apply Changes:?[yes]:
Press Enter to apply the changes or type
Step 7
Configuring NTP
This section describes how to configure a Cisco router to be an NTP server and how to configure the
sensor to use an NTP server as its time source. It contains the following topics:
•
•
78-16527-01
Changing the time zone offset requires the sensor to reboot.
offset: -360 minutes default: 0
standard-time-zone-name: CST default: UTC
Configuring a Cisco Router to be an NTP Server, page 4-28
Configuring the Sensor to Use an NTP Time Source, page 4-29
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
to discard them.
no
Configuring Time
4-27
Advertisement
Table of Contents
Troubleshooting
