Configuring The Catalyst 6500 Series Switch For Command And Control Access To Idsm-2; Catalyst Software - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Configuring the Catalyst 6500 Series Switch for Command and Control Access to IDSM-2

--- -------------------
1 Pass
2 Pass
3 Pass
6 Pass
7 Pass
9 Unknown
10 Not Applicable
11 Pass
13 Pass
router#
Note
For information on enabling a full memory test after verifying IDSM-2 installation, see
Memory Tests, page
Configuring the Catalyst 6500 Series Switch for Command and
Control Access to IDSM-2
You must configure the Catalyst 6500 series switch to have command and control access to IDSM-2.
This section describes how to configure the switch to have command and control access to IDSM-2, and
contains the following topics:
•
•

Catalyst Software

To configure the Catalyst 6500 series switch to have command and control access to IDSM-2, follow
these steps:
Log in to the console.
Step 1
Enter privileged mode:
Step 2
cat6k> enable
Put the command and control port into the correct VLAN:
Step 3
cat6k> (enable) set vlan command_and_control_vlan_number
idsm2_slot_number/command_and_control_port_number
Example:
cat6k> (enable) set vlan 147 6/2
VLAN 147 modified.
VLAN 146 modified.
VLAN
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
15-4
It is normal for the status to read
the diagnostics routines and comes online, the status reads
to come online.
15-24.
Catalyst Software, page 15-4
Cisco IOS Software, page 15-6
Mod/Ports
when IDSM-2 is first installed. After IDSM-2 completes
other
ok
Chapter 15 Configuring IDSM-2
. Allow up to 5 minutes for IDSM-2
Enabling Full
78-16527-01