Displaying Command History; Displaying Hardware Inventory - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Displaying Command History

Displaying Command History
Use the show history command to obtain a list of the commands you have entered in the current menu.
The maximum number of commands in the list is 50.
To obtain a list of the commands you have used recently, follow these steps:
Log in to the CLI.
Step 1
Show the history of the commands you have used in EXEC mode:
Step 2
sensor# show history
clear line
configure terminal
show history
Show the history of the commands you have used in network access mode:
Step 3
sensor# configure terminal
sensor (config)# service network-access
sensor (config-net)# show history
show settings
show settings terse
show settings | include profile-name|ip-address
exit
show history
sensor (config-net)#

Displaying Hardware Inventory

Use the show inventory command to display PEP information. This command displays the UDI
information that consists of the PID, the VID, and the SN of your sensor.
PEP information provides an easy way to obtain the hardware version and serial number through the CLI.
The show inventory command does not apply to the following platforms:
•
•
•
•
•
•
To display PEP information, follow these steps:
Step 1 Log in to the CLI.
Step 2 Display the PEP information:
sensor# show inventory
Name: "Chassis", DESCR: "IPS 4255 Intrusion Prevention Sensor"
PID: IPS-4255-K9, VID: V01 , SN: JAB0815R017
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
13-24
IDSM-2
NM-CIDS
IDS-4210
IDS-4215
IDS-4235
IDS-4250
Chapter 13 Administrative Tasks for the Sensor
78-16527-01