Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 485

Appendix C Troubleshooting
State
BlockEnable = true
NetDevice
NetDevice
NetDevice
NetDevice
NetDevice
BlockedAddr
sensor#
Display the statistics for the notification application:
Step 11
sensor# show statistics notification
General
Number of SNMP set requests = 0
78-16527-01
BlockInterface
InterfaceName = 502
InterfacePreBlock = Pre_Acl_Test
BlockInterface
InterfaceName = 507
InterfacePostBlock = Post_Acl_Test
IP = 10.89.150.171
AclSupport = Does not use ACLs
Version = 6.3
State = Active
Firewall-type = PIX
IP = 10.89.150.219
AclSupport = Does not use ACLs
Version = 7.0
State = Active
Firewall-type = ASA
IP = 10.89.150.250
AclSupport = Does not use ACLs
Version = 2.2
State = Active
Firewall-type = FWSM
IP = 10.89.150.158
AclSupport = uses Named ACLs
Version = 12.2
State = Active
IP = 10.89.150.138
AclSupport = Uses VACLs
Version = 8.4
State = Active
Host
IP = 22.33.4.5
Vlan =
ActualIp =
BlockMinutes =
Host
IP = 21.21.12.12
Vlan =
ActualIp =
BlockMinutes =
Host
IP = 122.122.33.4
Vlan =
ActualIp =
BlockMinutes = 60
MinutesRemaining = 24
Network
IP = 111.22.0.0
Mask = 255.255.0.0
BlockMinutes =
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
Gathering Information
C-59