Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 328

Installing System Images
Download the IDSM-2 system image file (WS-SVC-IDSM2-K9-sys-1.1-a-5.0-1.bin.gz) to the FTP root
Step 1
directory of a FTP server that is accessible from your IDSM-2. For the procedure for locating software
on Cisco.com, see
Step 2 Log in to the switch CLI.
Boot IDSM-2 to the maintenance partition:
Step 3
cat6k> (enable) reset module_number cf:1
Log in to the maintenance partition CLI:
Step 4
login: guest
Password: cisco
Note
Install the system image:
Step 5
guest@hostname.localdomain# upgrade ftp://user@ftp server IP/directory
path
Specify the FTP server password. After the application partition file has been downloaded, you are asked
Step 6
if you want to proceed:
Upgrading will wipe out the contents on the hard disk. Do you want to proceed installing
it [y|n]:
Type
Step 7
maintenance partition CLI.
Exit the maintenance partition CLI and return to the switch CLI.
Step 8
Reboot IDSM-2 to the application partition:
Step 9
cat6k> (enable) reset module_number hdd:1
When IDSM-2 has rebooted, check the software version. For the procedure, see
Step 10
Installation, page
Log in to the application partition CLI and initialize IDSM-2. For the procedure, see
Step 11
Sensor, page
Cisco IOS Software
To install the system image, follow these steps:
Download the IDSM-2 system image file (WS-SVC-IDSM2-K9-sys-1.1-a-5.0-1.bin.gz) to the TFTP
Step 1
root directory of a TFTP server that is accessible from your IDSM-2. For the procedure for locating
software on Cisco.com, see
Log in to the switch CLI.
Step 2
Boot IDSM-2 to the maintenance partition:
Step 3
router# hw-module module module_number reset cf:1
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
17-26
Obtaining Cisco IPS Software, page
You must configure the maintenance partition on IDSM-2. For the procedure, see
the Maintenance Partition, page
/
WS-SVC-IDSM2-K9-sys-1.1-a-5.0-1.bin.gz
to continue. When the application partition file has been installed, you are returned to the
y
15-2.
3-2.
Obtaining Cisco IPS Software, page
Chapter 17 Upgrading, Downgrading, and Installing System Images
18-1.
17-27.
18-1.
Configuring
Verifying IDSM-2
Initializing the
78-16527-01