Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 72

Configuring Time
Configure the end summertime parameters:
Step 6
Type the date you want to end summertime settings:
a.
sensor(config-hos-non-end)# date 2004-10-31
The format is yyyy-mm-dd.
Type the time you want to end summertime settings:
b.
sensor(config-hos-non-end)# time 12:00:00
The format is hh:mm:ss.
Verify your settings:
c.
sensor(config-hos-non-end)# show settings
sensor(config-hos-non-end)#
Specify the local time zone used during summertime:
Step 7
sensor(config-hos-non-end)# exit
sensor(config-hos-non)# summertime-zone-name CDT
Specify the offset:
Step 8
sensor(config-hos-non)# offset 60
Note
Verify your settings:
Step 9
sensor(config-hos-non)# show settings
non-recurring
-----------------------------------------------
-----------------------------------------------
sensor(config-hos-non)#
Exit non-recurring summertime submode:
Step 10
sensor(config-hos-non)# exit
sensor(config-hos)# exit
Apply Changes:?[yes]:
Step 11 Press Enter to apply the changes or type
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
4-26
end-summertime
-----------------------------------------------
date: 2004-10-31
time: 12:00:00
-----------------------------------------------
Changing the time zone offset requires the sensor to reboot.
offset: 60 minutes default: 60
summertime-zone-name: CDT
start-summertime
-----------------------------------------------
date: 2004-05-15
time: 12:00:00
-----------------------------------------------
end-summertime
-----------------------------------------------
date: 2004-10-31
time: 12:00:00
-----------------------------------------------
to discard them.
no
Chapter 4 Initial Configuration Tasks
78-16527-01