Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 253
Configuration guide
Hide thumbs
Also See for 4215 - Intrusion Detection Sys Sensor:
- Hardware installation manual (74 pages)
Table of Contents
Advertisement
Chapter 13
Administrative Tasks for the Sensor
-----------------------------------------------
cat6k-devices (min: 0, max: 250, current: 1)
-----------------------------------------------
-----------------------------------------------
router-devices (min: 0, max: 250, current: 1)
78-16527-01
password: <hidden>
username: <defaulted>
-----------------------------------------------
profile-name: fwsm
-----------------------------------------------
enable-password: <hidden>
password: <hidden>
username: pix default:
-----------------------------------------------
profile-name: outsidePix
-----------------------------------------------
enable-password: <hidden>
password: <hidden>
username: pix default:
-----------------------------------------------
profile-name: cat
-----------------------------------------------
enable-password: <hidden>
password: <hidden>
username: <defaulted>
-----------------------------------------------
profile-name: rcat
-----------------------------------------------
enable-password: <hidden>
password: <hidden>
username: cisco default:
-----------------------------------------------
profile-name: nopass
-----------------------------------------------
enable-password: <hidden>
password: <hidden>
username: <defaulted>
-----------------------------------------------
profile-name: test
-----------------------------------------------
enable-password: <hidden>
password: <hidden>
username: pix default:
-----------------------------------------------
profile-name: sshswitch
-----------------------------------------------
enable-password: <hidden>
password: <hidden>
username: cisco default:
-----------------------------------------------
ip-address: 10.89.147.61
-----------------------------------------------
communication: telnet default: ssh-3des
nat-address: 0.0.0.0 <defaulted>
profile-name: cat
block-vlans (min: 0, max: 100, current: 1)
-----------------------------------------------
vlan: 1
-----------------------------------------------
pre-vacl-name: <defaulted>
post-vacl-name: <defaulted>
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
Displaying Submode Settings
13-27
Advertisement
Table of Contents
Troubleshooting
