Cisco Ios Software - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Configuring the Catalyst Series 6500 Switch for IDSM-2 in Promiscuous Mode
Note

Cisco IOS Software

Use the monitor session command in global configuration mode to enable SPAN on IDSM-2.
Use 1 or 2 for IDSM-2 data port numbers.
Note
The following options apply:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
To enable SPAN on IDSM-2, follow these steps:
Log in to the console.
Step 1
Step 2 Enter global configuration mode:
router# configure terminal
Step 3 Set the source interfaces for the monitor session:
router (config)# monitor session (session_number) source interface interface/port_number
[, | - | rx | tx | both]
Example:
router (config)# monitor session 1 source interface GigabitEthernet2/23 both
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
15-10
For more information on SPAN, refer to the appropriate Catalyst 6500 Series Switch Command
Reference.
interface—SPAN source interface
remote—SPAN source Remote
vlan— SPAN source VLAN
GigabitEthernet— GigabitEthernet IEEE 802.3z
Port-channel— Ethernet Channel of interfaces
,— Specify another range of interfaces
--— Specify a range of interfaces
both— Monitor received and transmitted traffic
rx— Monitor received traffic only
tx— Monitor transmitted traffic only
intrusion-detection-module— SPAN destination intrusion detection module
destination— SPAN destination interface or VLAN
filter— SPAN filter VLAN
source— SPAN source interface, VLAN
type— Type of monitor session
Chapter 15 Configuring IDSM-2
78-16527-01