Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 254

Displaying Submode Settings
-----------------------------------------------
-----------------------------------------------
firewall-devices (min: 0, max: 250, current: 2)
-----------------------------------------------
-----------------------------------------------
sensor (config-net)#
Show the Network Access Controller settings in terse mode:
Step 3
sensor(config-net)# show settings terse
general
-----------------------------------------------
-----------------------------------------------
user-profiles (min: 0, max: 250, current: 11)
-----------------------------------------------
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
13-28
ip-address: 10.89.147.54
-----------------------------------------------
communication: telnet default: ssh-3des
nat-address: 0.0.0.0 <defaulted>
profile-name: r7200
block-interfaces (min: 0, max: 100, current: 1)
-----------------------------------------------
interface-name: fa0/0
direction: in
-----------------------------------------------
pre-acl-name: <defaulted>
post-acl-name: <defaulted>
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
ip-address: 10.89.147.10
-----------------------------------------------
communication: telnet default: ssh-3des
nat-address: 0.0.0.0 <defaulted>
profile-name: insidePix
-----------------------------------------------
ip-address: 10.89.147.82
-----------------------------------------------
communication: ssh-3des <defaulted>
nat-address: 0.0.0.0 <defaulted>
profile-name: f1
-----------------------------------------------
log-all-block-events-and-errors: true <defaulted>
enable-nvram-write: false <defaulted>
enable-acl-logging: false <defaulted>
allow-sensor-block: false <defaulted>
block-enable: true <defaulted>
block-max-entries: 250 <defaulted>
max-interfaces: 250 default: 250
master-blocking-sensors (min: 0, max: 100, current: 0)
-----------------------------------------------
-----------------------------------------------
never-block-hosts (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
never-block-networks (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
block-hosts (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
block-networks (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
Chapter 13 Administrative Tasks for the Sensor
78-16527-01