Overview - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Introducing the CLI Configuration Guide
This chapter introduces Configuring the Cisco Intrusion Prevention System Sensor Using the Command
Line Interface 5.0. It contains the following sections:
•
•
•
•
•
•
•
•
•

Overview

This guide is a task-based configuration guide for the IPS 5.0 CLI. The term "sensor" is used throughout
this guide to refer to all sensor models, unless a procedure refers specifically to the appliance or one of
the modules, such as IDSM-2, NM-CIDS, or AIP-SSM.
Refer to the
IPS commands. Refer to the
shipped with your sensor for information on locating all IPS 5.0 documents on Cisco.com.
You can also use an IPS manager to configure your sensor. Refer to the
Cisco Intrusion Prevention System 5.0
documentation that describes how to use IDM and ASDM.
78-16527-01
Overview, page 1-1
Sensor Configuration Task Flow, page 1-2
User Roles, page 1-3
CLI Behavior, page 1-4
Command Line Editing, page 1-5
IPS Command Modes, page 1-6
Regular Expression Syntax, page 1-7
General CLI Commands, page 1-9
CLI Keywords, page 1-9
Command Reference for Cisco Intrusion Prevention System 5.0
Documentation Roadmap for Cisco Intrusion Prevention System 5.0
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
C H A P T E R
that shipped with your sensor for information on how to access
1
for an alphabetical list of all
that
Documentation Roadmap for
1-1