Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 207

Configuration guide
Hide thumbs Also See for 4215 - Intrusion Detection Sys Sensor:
Table of Contents

Advertisement

Chapter 11
Configuring SNMP
Set the parameters for the SNMP trap destinations so the sensor knows which management workstations
Step 5
to send them to:
a.
Type the IP address of the SNMP management station:
sensor(config-not)# trap-destinations 10.1.1.1
Type the UDP port of the SNMP management station:
b.
sensor(config-not-tra)# trap-port 162
The default is 162.
Type the trap Community string:
c.
sensor(config-not-tra)# trap-community-name AUSTIN_PUBLI
Note
Step 6
Verify the settings:
sensor(config-not-tra)# exit
sensor(config-not)# show settings
trap-destinations (min: 0, max: 10, current: 1)
-----------------------------------------------
-----------------------------------------------
error-filter: warning|error|fatal default: error|fatal
enable-detail-traps: true default: false
enable-notifications: true default: false
enable-set-get: true default: false
snmp-agent-port: 161 default: 161
snmp-agent-protocol: udp default: udp
read-only-community: PUBLIC1 default: public
read-write-community: PRIVATE1 default: private
trap-community-name: PUBLIC1 default: public
system-location: AUSTIN default: Unknown
system-contact: BUSINESS default: Unknown
sensor(config-not)#
Exit notification submode:
Step 7
sensor(config-not)# exit
Apply Changes:?[yes]:
Press Enter to apply the changes or type
Step 8
78-16527-01
The community string appears in the trap and is useful if you are receiving multiple types of
traps from multiple agents. For example, a router or sensor could be sending the traps, and
if you put something that identifies the router or sensor specifically in your community
string, you can filter the traps based on the community string.
ip-address: 10.1.1.1
-----------------------------------------------
trap-community-name: AUSTIN_PUBLIC default:
trap-port: 161 default: 162
-----------------------------------------------
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
to discard them.
no
Configuring SNMP Traps
11-5

Advertisement

Table of Contents
loading

Table of Contents