Cannot Launch Idm -Analysis Engine Busy; Idm, Remote Manager, Or Sensing Interfaces Cannot Access The Sensor - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Appendix C Troubleshooting
Delete the temp files and clear the history in the browser.
Step 4

Cannot Launch IDM -Analysis Engine Busy

Error Message Error connecting to sensor. Failed to load
sensor-errNotAvailable-Analysis Engine is busy. Exiting IDM.

IDM, Remote Manager, or Sensing Interfaces Cannot Access the Sensor

If IDM, a remote manager, or sensing interfaces cannot access the sensor, but you can access the sensor's
CLI using SSH or Telnet (if enabled), follow these steps:
Note For the procedure for enabling and disabling Telnet on the sensor, see
page
Step 1 Make sure the network configuration allows access to the web server port that is configured on the
sensor:
sensor# setup
At any point you may enter a question mark '?' for help.
User ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Current Configuration:
service host
network-settings
host-ip 10.89.130.108/23,10.89.130.1
host-name sensor
telnet-option enabled
access-list 0.0.0.0/0
ftp-timeout 300
no login-banner-text
exit
time-zone-settings
offset 0
standard-time-zone-name UTC
exit
summertime-option disabled
ntp-option disabled
exit
78-16527-01
This condition can occur if the Analysis Engine in the sensor is busy getting ready
Possible Cause
to perform a task and so does not respond to IDM.
Recommended Action Wait for a while and try again to connect.
4-4,.
--- System Configuration Dialog ---
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
Troubleshooting IDM
Enabling and Disabling Telnet,
C-37