Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 42

Initializing the Sensor
Specify the Telnet server status.
Step 8
You can disable or enable Telnet services. The default is disabled.
Specify the web server port.
Step 9
The web server port is the TCP port used by the web server (1 to 65535). The default is 443.
Note
Note
Step 10 Type
yes
a. If you want to delete an entry, type the number of the entry and press Enter, or press Enter to get
to the Permit line.
b. Type the IP address and netmask of the network you want to add to the access list.
The IP interface is in the form of IP Address/Netmask/Gateway: X.X.X.X/nn,Y.Y.Y.Y, where
X.X.X.X specifies the sensor IP address as a 32-bit address written as 4 octets separated by periods
where X = 0-255, nn specifies the number of bits in the netmask, and Y.Y.Y.Y specifies the default
gateway as a 32-bit address written as 4 octets separated by periods where Y = 0-255.
Repeat Step b until you have added all networks that you want to add to the access list.
c.
Press Enter at a blank permit line to proceed to the next step.
d.
Type
Step 11
yes
Type
a.
You will need the NTP server IP address, the NTP key ID, and the NTP key value. If you do not have
those at this time, you can configure NTP later. For the procedure, see
Use an NTP Time Source, page
Type
b.
Note
Choose recurring, date, or disable to specify how you want to configure summertime settings.
c.
The default is recurring.
If you chose recurring, specify the month you want to start summertime settings.
d.
Valid entries are january, february, march, april, may, june, july, august, september, october,
november, and december.
The default is april.
Specify the week you want to start summertime settings.
e.
Valid entries are first, second, third, fourth, fifth, and last.
The default is first.
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
3-4
If you change the web server port, you must specify the port in the URL address of your browser
when you connect to the IDM in the format
https://10.1.9.201:1040
The web server is configured to use TLS and SSL encryption by default. Setting the port to 80
does not disable the encryption.
to modify the network access list.
to modify the system clock settings.
if you want to use NTP.
yes
to modify summertime settings.
yes
Summertime is also known as DST. If your location does not use Summertime, go to Step n.
https://
).
4-29.
Chapter 3 Initializing the Sensor
sensor_ip_ address (for example,
:port
Configuring the Sensor to
78-16527-01