Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 215
Configuration guide
Hide thumbs
Also See for 4215 - Intrusion Detection Sys Sensor:
- Hardware installation manual (74 pages)
Table of Contents
Advertisement
Chapter 12
Working With Configuration Files
-----------------------------------------------
sensor(config-log)# exit
sensor(config)# exit
sensor#
Display the current configuration for the service network access submode:
Step 8
sensor# configure terminal
sensor(config)# service network-access
sensor(config-net)# show settings
general
-----------------------------------------------
-----------------------------------------------
user-profiles (min: 0, max: 250, current: 1)
-----------------------------------------------
-----------------------------------------------
cat6k-devices (min: 0, max: 250, current: 1)
-----------------------------------------------
-----------------------------------------------
router-devices (min: 0, max: 250, current: 0)
78-16527-01
zone-name: cplane
severity: warning <defaulted>
log-all-block-events-and-errors: true <defaulted>
enable-nvram-write: false <defaulted>
enable-acl-logging: false <defaulted>
allow-sensor-block: false <defaulted>
block-enable: true <defaulted>
block-max-entries: 250 <defaulted>
max-interfaces: 250 <defaulted>
master-blocking-sensors (min: 0, max: 100, current: 0)
-----------------------------------------------
-----------------------------------------------
never-block-hosts (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
never-block-networks (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
block-hosts (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
block-networks (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
profile-name: test1
-----------------------------------------------
enable-password: <hidden>
password: <hidden>
username: <defaulted>
-----------------------------------------------
ip-address: 1.1.1.1
-----------------------------------------------
communication: ssh-3des default: ssh-3des
nat-address: 0.0.0.0 <defaulted>
profile-name: test1
block-vlans (min: 0, max: 100, current: 1)
-----------------------------------------------
vlan: 234
-----------------------------------------------
pre-vacl-name: aaaa default:
post-vacl-name: bbbb default:
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
Displaying the Current Submode Configuration
12-7
Advertisement
Table of Contents
Troubleshooting
