Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 339

Configuration guide
Hide thumbs Also See for 4215 - Intrusion Detection Sys Sensor:
Table of Contents

Advertisement

Chapter 17
Upgrading, Downgrading, and Installing System Images
Note
Step 4
Specify the TFTP URL for the system image:
Image URL [tftp://0.0.0.0/]:
Example:
Image URL [tftp://0.0.0.0/]: tftp://10.89.146.1/IPS-SSM-K9-sys-1.1-a-5.0-1.img
Specify the command and control interface of AIP-SSM:
Step 5
Port IP Address [0.0.0.0]:
Example:
Port IP Address [0.0.0.0]: 10.89.149.231
Leave the VLAN ID at 0.
Step 6
VLAN ID [0]:
Specify the default gateway of the AIP-SSM:
Step 7
Gateway IP Address [0.0.0.0]:
Example:
Gateway IP Address [0.0.0.0]: 10.89.149.254
Execute the recovery:
Step 8
asa# hw-module module 1 recover boot
Periodically check the recovery until it is complete:
Step 9
Note
asa# show module 1
Mod Card Type
--- -------------------------------------------- ------------------ -----------
0 ASA 5540 Adaptive Security Appliance
1 ASA 5500 Series Security Services Module-20
Mod MAC Address Range
--- --------------------------------- ------------ ------------ ---------------
0 000b.fcf8.7b1c to 000b.fcf8.7b20
1 000b.fcf8.011e to 000b.fcf8.011e
Mod Status
--- ------------------
0 Up Sys
1 Up
asa#
Note
78-16527-01
If you make an error in the recovery configuration, use the hw-module module 1 recover stop
command to stop the system reimaging and then you can correct the configuration.
The status reads
Recovery
To debug any errors that may happen in the recovery process, use the debug module-boot
command to enable debugging of the system reimaging process.
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
during recovery and reads
Model
ASA5540
AIP-SSM-20
Hw Version
Fw Version
0.2
1.0(7)2
0.1
1.0(7)2
Installing System Images
when reimaging is complete.
Up
Serial No.
P2B00000019
P1D000004F4
Sw Version
7.0(0)82
5.0(0.22)S129.0
17-37

Advertisement

Table of Contents
loading

Table of Contents