Cisco Ios Software - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Configuring the Catalyst 6500 Series Switch for Command and Control Access to IDSM-2

Cisco IOS Software

To configure the Catalyst 6500 series switch to have command and control access to IDSM-2, follow
these steps:
Log in to the console.
Step 1
Enter global configuration mode:
Step 2
router# configure terminal
Put the command and control port into the correct VLAN:
Step 3
router (config)# intrusion-detection module module_number management-port access-vlan
vlan_number
Example:
router (config)# intrusion-detection module 11 management-port access-vlan 146
Verify that you have connectivity by sessioning in to IDSM-2 and pinging a network IP address:
Step 4
router# session slot module_number processor 1
idsm-2# ping network_ip_address
Example:
router# session slot 11 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.91 ... Open
login: cisco
Password:
***NOTICE***
This product contains cryptographic features and is subject to United States and local
country laws governing import, export, transfer and use. Delivery of Cisco cryptographic
products does not imply third-party authority to import, export, distribute or use
encryption. Importers, exporters, distributors and users are responsible for compliance
with U.S. and local country laws. By using this product you agree to comply with
applicable laws and regulations. If you are unable to comply with U.S. and local laws,
return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
***LICENSE NOTICE***
There is no license key installed on the system.
Please go to http://www.cisco.com/go/license
to obtain a new license or install a license.
idsm-2# ping 10.89.149.254
PING 10.89.149.254 (10.89.149.254): 56 data bytes
64 bytes from 10.89.149.254: icmp_seq=0 ttl=255 time=0.2 ms
64 bytes from 10.89.149.254: icmp_seq=1 ttl=255 time=0.2 ms
64 bytes from 10.89.149.254: icmp_seq=2 ttl=255 time=0.2 ms
64 bytes from 10.89.149.254: icmp_seq=3 ttl=255 time=0.2 ms
--- 10.89.149.254 ping statistics ---
4 packets transmitted, 4 packets received, 0% packet loss
round-trip min/avg/max = 0.2/0.2/0.2 ms
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
15-6
Chapter 15 Configuring IDSM-2
78-16527-01