Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 323

Chapter 17 Upgrading, Downgrading, and Installing System Images
Note
Step 5 Suspend the session by pressing Shift-Ctrl-6 X. You will see the
prompt, try Ctrl-6 X.
Step 6 Reset NM-CIDS:
router(enable)# service-module IDS-Sensor slot_number/0 reset
You are prompted to confirm the reset command.
Press Enter to confirm.
Step 7
Press Enter to resume the suspended session. After displaying its version, the bootloader displays this
Step 8
prompt for 15 seconds:
Please enter '***' to change boot configuration:
Step 9 Type
***
Display the bootloader configuration:
Step 10
ServicesEngine boot-loader> show config
Caution If the bootloader version is not 1.0.17-1, you must upgrade it before installing 5.0. For the procedure,
see Upgrading the Bootloader, page
Configure the bootloader parameters:
Step 11
ServicesEngine boot-loader> config
You are prompted for each value line by line.
Step 12
a. Specify the IP address—The external fast Ethernet port on NM-CIDS. This must be a real IP address
on your network.
Specify the subnet mask—The external fast Ethernet port on NM-CIDS. This must be a real IP
b.
address on your network.
Specify the TFTP server IP address—The IP address of the TFTP server from which to download
c.
the NM-CIDS system image.
Specify the gateway IP address—The IP address of the default gateway for hosts on your subnet.
d.
Specify the default helper file—The name of the helper image to boot. The NM-CIDS helper file is
e.
boot helper IPS-NM-CIDS-K9-sys-1.1-a-5.0-1.img.
Note
Specify the Ethernet interface—The Ethernet interface is always set to external.
f.
Specify the default boot device—The default boot device is always set to disk.
g.
Specify the default bootloader—The default bootloader is always set to primary.
h.
If you made any changes, the bootloader stores them permanently. The bootloader command prompt
appears.
78-16527-01
Use the show configuration | include interface IDS-Sensor command to determine the
NM-CIDS slot number.
during the 15-second delay. The bootloader prompt appears.
4.x had a separate helper file, NM-CIDS-K9-helper-1.0-1.bin, but in 5.0 the system image
file is its own helper file.
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
17-22.
Installing System Images
prompt. If you do not see this
router#
17-21