Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 69

Chapter 4 Initial Configuration Tasks
This section contains the following topics:
•
•
Configuring Recurring Summertime Settings
Use the summertime-option recurring command to configure the sensor to switch to summertime
settings on a recurring basis. The default is recurring.
To configure the sensor to switch to summertime settings on a recurring basis, follow these steps:
Log in to the sensor using an account with administrator privileges.
Step 1
Enter summertime recurring submode:
Step 2
sensor# configure terminal
sensor(config)# service host
sensor(config-hos)# summertime-option recurring
Enter start summertime submode:
Step 3
sensor(config-hos-rec)# start-summertime
Configure the start summertime parameters:
Step 4
d.
e.
f.
g.
h.
Enter end summertime submode:
Step 5
sensor(config-hos-rec-sta)# exit
sensor(config-hos-rec)# end-summertime
78-16527-01
Configuring Recurring Summertime Settings, page 4-23
Configuring Non-recurring Summertime Settings, page 4-25
Type the day of the week you want to start summertime settings:
sensor(config-hos-rec-sta)# day-of-week monday
Type the month you want to start summertime settings:
sensor(config-hos-rec-sta)# month april
Type the time of day you want to start summertime settings:
sensor(config-hos-rec-sta)# time-of-day 12:00:00
The format is hh:mm:ss.
Type the week of the month you want to start summertime settings:
sensor(config-hos-rec-sta)# week-of-month first
The values are first through fifth, or last.
Verify your settings:
sensor(config-hos-rec-sta)# show settings
start-summertime
-----------------------------------------------
month: april default: april
week-of-month: first default: first
day-of-week: monday default: sunday
time-of-day: 12:00:00 default: 02:00:00
-----------------------------------------------
sensor(config-hos-rec-sta)#
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
Configuring Time
4-23