Supported Cisco Ios Commands - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Supported Cisco IOS Commands

Something similar to the following output appears:
Router# service-module ids-sensor 1/0 status
Service Module is Cisco IDS-Sensor 1/0
Service Module supports session via TTY line 33
Service Module is in Steady state
Getting status from the Service Module, please wait..
Service Module Version information received,
Major ver = 1, Minor ver= 1
Cisco Systems Intrusion Detection System Network Module
Software version: 5.0(1)S42
Model: NM-CIDS
Memory: 254676 KB
Mgmt IP addr:
Mgmt web ports:
Mgmt TLS enabled:
Supported Cisco IOS Commands
The service-module ids-sensor slot_number/0 Cisco IOS command is new to support NM-CIDS. The
slot number can vary, but the port is always 0.
The following options apply:
•
Removing the NM-CIDS without proper shutdown can result in the hard-disk drive being corrupted.
Caution
After successful shutdown of the NM-CIDS applications, Cisco IOS prints a message indicating that you
can now remove NM-CIDS.
•
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
16-8
xx.xx.xx.xx
443
true
Privileged mode EXEC
service-module ids-sensor slot_number/0 reload
–
Reloads the operating system on NM-CIDS.
service-module ids-sensor slot_number/0 reset
–
Provides a hardware reset to NM-CIDS.
service-module ids-sensor slot_number/0 session
–
The session command lets you access the IPS console.
– service-module ids-sensor slot_number/0 shutdown
Shuts down the IPS applications running on NM-CIDS.
service-module ids-sensor slot_number/0 status
–
Provides information on the status of the Cisco IPS software.
Configure interfaces mode
ids-service-module monitoring
–
You can enable IPS monitoring on a specified interface (or subinterface). Both inbound and
outbound packets on the specified interface are forwarded for monitoring.
(config-if)
Chapter 16 Configuring NM-CIDS
78-16527-01