Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 214

Displaying the Current Submode Configuration
command-control: GigabitEthernet0/0 <protected>
bypass-mode: auto <defaulted>
interface-notifications
-----------------------------------------------
-----------------------------------------------
sensor(config-int)# exit
sensor(config)# exit
sensor#
Display the current configuration for the service logger submode:
Step 7
sensor# configure terminal
sensor(config)# service logger
sensor(config-log)# show settings
master-control
-----------------------------------------------
-----------------------------------------------
zone-control (min: 0, max: 999999999, current: 14)
-----------------------------------------------
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
12-6
missed-percentage-threshold: 0 percent <defaulted>
notification-interval: 30 seconds <defaulted>
idle-interface-delay: 30 seconds <defaulted>
enable-debug: false <defaulted>
individual-zone-control: false <defaulted>
<protected entry>
zone-name: Cid
severity: debug <defaulted>
<protected entry>
zone-name: AuthenticationApp
severity: warning <defaulted>
<protected entry>
zone-name: Cli
severity: warning <defaulted>
<protected entry>
zone-name: csi
severity: warning <defaulted>
<protected entry>
zone-name: ctlTransSource
severity: warning <defaulted>
<protected entry>
zone-name: IdapiCtlTrans
severity: warning <defaulted>
<protected entry>
zone-name: IdsEventStore
severity: warning <defaulted>
<protected entry>
zone-name: MpInstaller
severity: warning <defaulted>
<protected entry>
zone-name: nac
severity: warning <defaulted>
<protected entry>
zone-name: sensorApp
severity: warning <defaulted>
<protected entry>
zone-name: tls
severity: warning <defaulted>
<protected entry>
zone-name: intfc
severity: warning <defaulted>
<protected entry>
zone-name: cmgr
severity: warning <defaulted>
<protected entry>
Chapter 12 Working With Configuration Files
78-16527-01