Configuring Aip-Ssm; Configuration Sequence - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Configuring AIP-SSM

This chapter contains procedures that are specific to configuring AIP-SSM. It contains the following
sections:
•
•
•
•

Configuration Sequence

Perform the following tasks to configure AIP-SSM:
1.
2.
3.
4.
5.
6.
7.
78-16527-01
Configuration Sequence, page 14-1
Verifying AIP-SSM Initialization, page 14-2
Sending Traffic to AIP-SSM, page 14-2
Reloading, Shutting Down, Resetting, and Recovering AIP-SSM, page 14-5
Log in to AIP-SSM.
For the procedure, see Logging In to AIP-SSM, page
Initialize AIP-SSM.
Run the setup command to initialize AIP-SSM.
For the procedure, see Initializing the Sensor, page
Verify the AIP-SSM initialization.
For the procedure, see Verifying AIP-SSM Initialization, page
Configure ASA to send IPS traffic to AIP-SSM.
For the procedure, see Sending Traffic to AIP-SSM, page
Perform other initial tasks, such as adding users, trusted hosts, and so forth.
For the procedures, see Chapter 4, "Initial Configuration Tasks."
Configure intrusion prevention.
For the procedures, see Chapter 6, "Configuring Event Action Rules," Chapter 7, "Defining
Signatures," and Chapter 10, "Configuring Blocking."
Perform miscellaneous tasks to keep your AIP-SSM running smoothly.
For the procedures, see Chapter 13, "Administrative Tasks for the Sensor."
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
14
C H A P T E R
2-7.
3-2.
14-2.
14-2.
14-1