Adding A Login Banner - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Changing Network Settings
Change the value back to the default:
Step 5
sensor(config-hos-net)# default ftp-timeout
Verify the value has been set back to the default:
Step 6
sensor(config-hos-net)# show settings
network-settings
-----------------------------------------------
-----------------------------------------------
sensor(config-hos-net)#
Step 7 Exit network settings mode:
sensor(config-hos-net)# exit
sensor(config-hos)# exit
Apply Changes:?[yes]:
Press Enter to apply the changes or type
Step 8

Adding a Login Banner

Use the login-banner-text text_message command to add a login banner that the user sees during login.
There is no default.
When you want to start a new line in your message, press Ctrl-V Enter.
To add a login banner, follow these steps:
Log in to the sensor using an account with administrator privileges.
Step 1
Enter network settings mode:
Step 2
sensor# configure terminal
sensor(config)# service host
sensor(config-hos)# network-settings
Step 3 Add the banner login text:
sensor(config-hos-net)# login-banner-text This is the banner login text message.
Step 4 Verify the banner login text message:
sensor(config-hos-net)# show settings
network-settings
-----------------------------------------------
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
4-8
host-ip: 10.89.130.108/23,10.89.130.1
default: 10.1.9.201/24,10.1.9.1
host-name: sensor default: sensor
telnet-option: enabled default: disabled
access-list (min: 0, max: 512, current: 1)
-----------------------------------------------
network-address: 0.0.0.0/0
-----------------------------------------------
-----------------------------------------------
ftp-timeout: 300 seconds <defaulted>
login-banner-text: <defaulted>
host-ip: 10.89.130.108/23,10.89.130.1
default: 10.1.9.201/24,10.1.9.1
host-name: sensor default: sensor
telnet-option: enabled default: disabled
to discard them.
no
Chapter 4 Initial Configuration Tasks
78-16527-01