Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 333
Configuration guide
Hide thumbs
Also See for 4215 - Intrusion Detection Sys Sensor:
- Hardware installation manual (74 pages)
Table of Contents
Advertisement
Chapter 17
Upgrading, Downgrading, and Installing System Images
guest@idsm2.localdomain#
Clear the upgrade log:
Step 14
guest@idsm2.localdomain# clear log upgrade
Cleared log file successfully
Display the upgrade log:
Step 15
guest@idsm2.localdomain# show log upgrade
guest@idsm2.localdomain#
Ping another computer:
Step 16
guest@idsm2.localdomain# ping 10.89.146.114
PING 10.89.146.114 (10.89.146.114) from 10.89.149.74 : 56(84) bytes of data.
64 bytes from 10.89.146.114: icmp_seq=0 ttl=254 time=381 usec
64 bytes from 10.89.146.114: icmp_seq=1 ttl=254 time=133 usec
64 bytes from 10.89.146.114: icmp_seq=2 ttl=254 time=129 usec
64 bytes from 10.89.146.114: icmp_seq=3 ttl=254 time=141 usec
64 bytes from 10.89.146.114: icmp_seq=4 ttl=254 time=127 usec
--- 10.89.146.114 ping statistics ---
5 packets transmitted, 5 packets received, 0% packet loss
round-trip min/avg/max/mdev = 0.127/0.182/0.381/0.099 ms
guest@idsm2.localdomain#
Reset IDSM-2:
Step 17
Note
guest@idsm2.localdomain# reset
guest@idsm2.localdomain#
2005 Mar 11 21:55:46 CST -06:00 %SYS-4-MOD_SHUTDOWNSTART:Module 9 shutdown in progress. Do
not remove module until shutdown completes
Broadcast message from root Fri Mar 11 21:55:47 2005...
The system is going down for system halt NOW !!
cat6k> (enable)
Cisco IOS Software
To configure the IDSM-2 maintenance partition, follow these steps:
Step 1
Log in to the switch CLI.
Session to IDSM-2:
Step 2
router# session slot 11 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.111 ... Open
Cisco Maintenance image
78-16527-01
You cannot specify a partition when issuing the reset command from the maintenance partition.
IDSM-2 boots to whichever partition is specified in the boot device variable. If the boot device
variable is blank, IDSM-2 boots to the application partition.
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
Installing System Images
17-31
Advertisement
Table of Contents
Troubleshooting
