Installing The Idsm-2 System Image; Installing The System Image - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Chapter 17 Upgrading, Downgrading, and Installing System Images
Type y to confirm. The bootloader is now upgraded to version 1.0.17-1. Continue only if you want to
Step 19
install the NM-CIDS system image now.
Step 20 After BIOS POST is completed on NM-CIDS, when you see the following message, type three asterisks:
Please enter '***' to change boot configuration:
The next step erases all data from the NM-CIDS hard-disk drive.
Caution
The boot loader prompt appears.
Step 21 Boot the NM-CIDS system image:
ServicesEngine boot-loader> boot helper IPS-NM-CIDS-K9-sys-1.1-a-5.0-1.img
The bootloader displays a spinning line while loading the system image from the TFTP server. When the
system image is loaded, it is booted. The system image installs IPS 5.0(1) on NM-CIDS. When the
installation is complete, NM-CIDS reboots. The system is restored to all default settings. The user
account and password are set to
You must initialize your NM-CIDS with the setup command. For the procedure, see
Sensor, page

Installing the IDSM-2 System Image

If the IDSM-2 application partition becomes unusable, you can reimage it from the maintenance
partition. After you reimage the application partition of IDSM-2, you must initialize IDSM-2 using the
setup command. For the procedure, see
When there is a new maintenance partition image file, you can reimage the maintenance partition from
the application partition. This section describes how to reimage the application partition and
maintenance partition for Catalyst software and Cisco IOS software.
This section contains the following topics:
•
•
•

Installing the System Image

This section describes how to install the IDSM-2 system image, and contains the following topics:
•
•
Catalyst Software
To install the system image, follow these steps:
78-16527-01
3-2.
Installing the System Image, page 17-25
Configuring the Maintenance Partition, page 17-27
Upgrading the Maintenance Partition, page 17-35
Catalyst Software, page 17-25
Cisco IOS Software, page 17-26
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
.
cisco
Initializing the Sensor, page
Installing System Images
Initializing the
3-2.
17-25